Charcoal rods making machine product charcoal of high density,
small volume, good flammability, would alternative to firewood and
coal. The product general diameter is 50-60mm, aperture is 15-20mm,
is hollow four or six corner column. The product is especially
suitable for northern area heating in winter, greenhouse warming or
ordinary life fuel. the full set of equipment of charcoal machine
includes rod making machine, charring furnace, drying machines and
Charcoal rods making machine application:
Charcoal rods making machine is the device for the raw
material(such as wood, sawdust, peanut shells, corn, sugarcane
bagasse, cotton stalk, corn stalk, rice husk, sawdust,
miscellaneous branches and so on) cruse into the granular within
10mm. the moisture content of less than 12% after drying, enter the
bar make shape by the high temperature high pressure(do not add any
additives),into the carbonization furnace(self-built kiln ) to
carbonization, is the finished product charcoal.
Introduction of charcoal rods making machine:
Raw material: wood, branches, sawdust, straw, peanut hull, corncob,
boll hull, sunflower hull, coconut shell, etc.
Moisture of raw material: around 12%.
Product shape: long bars in square shape or with hexagonal shape.
Charcoal rods (semifinished product) moisture: 2.1%
Charcoal rods (semifinished product) density: 1.2-1.5g/cm3
Charcoal rods (semifinished product) heat value: 19.79MJ
Dimensions of machine: 1350*850*630mm(L*W*H)